4030446 - steel
4064881 - steel
4031001 - steel
The clamp should be tightened on the ceramic part through use of a mallet. Later the piece is applied in the place and the clamp goes to the point of fixation resorting to its stainless steel cord.
Fixation of spout and eave over tiles to malleable substrates (bituminous sub-tile substrates) or to stone cornices (to avoid drilling of the cornice).
Fixing of Lusa half-tiles and other hedge parts. | Fixing cut parts in the roof ridges, corners and draining valleys.
4031002 - red
4030445 - steel
4064882 - red clay
4030461 - inox
The clamp should be fastened to the top part of the traditional Canudo clay tile and placed on it, in order to help with overlapping/fixing the next tile.
Note: if the slopes have pitches of more than 50% and lengths are greater than 4.0 m,the mechanical fixing should be made with an intermediate screw for a drilled over tile. For more information/clarifications consult theUM Canudo Installation Guide or contact UMBELINO MONTEIRO’s Technical Department.
4030461 - inox
4055255 - zinc
Laying diagram: The fixation part is placed on one side and approximately halfway between the spout/eave tile, depending on how far the part overhangs. It is usually fixed at the same point of the PVC protection mesh using the appropriate screw.
Notes: Due to its versatile design, this part is also used in situations where there is a need for additional fixing.
Find your nearest point of sale.